Supermicro SuperServer SYS-221H-TNR - AIOM Network Cards

63
Chapter 3: Maintenance and Component Installation
Installing AIOM Cards
1. Remove power as described in Section 3.1.
2. Remove the blank cover plate (
A1
or
A2
), unscrewing the thumbscrew.
3. Slide the AIOM card in the opening until it seats in the connector slot.
4. Secure with the thumbscrew.
Figure 3-10. Installing AIOMs
3.10 AIOM Network Cards
The system provides network connection by means of up to two AIOMs OCP 3.0 network
port cards. The second AIOM slot A2 is optional.
Figure 3-9. AIOM Chassis Slot
A2
A1
AIOM Conguration
Item Mechanical Electrical Thermal
A1
Small Form Factor, OCP 3.0 x16 (CPU1) Up to 15W*
A2
(Optional)
Small Form Factor, OCP 3.0 x16 (CPU2) Up to 15W*
*AIOM cards exceeding the 15W Slot Power Envelope may require restricted conditions to
meet thermal specications of the AIOM card. Contact your Supermicro account representative
for more information.