Supermicro SuperServer SYS-221H-TNR - Removing the Processor Carrier Assembly from the PHM

49
Chapter 3: Maintenance and Component Installation
Removing the Processor Carrier Assembly from the PHM
To remove the processor carrier assembly from the PHM, please follow the steps below:
1. Detach the four plastic clips (marked a, b, c, d) on the processor carrier assembly from
the four corners of the heatsink (marked A, B, C, D) as shown in the drawings below.
Pin 1
a
c
b
d
A
C
D
B
Pin 1
a
c
b
d
A
C
D
B
Pin 1
a
c
b
d
A
C
D
B
SP XCC Series Max Series (HBM)
SP MCC Series
2U Heatsink (View of Component Side & Heatsink Bottom Side)
2. When all plastic clips are detached from the heatsink, remove the processor carrier
assembly from the heatsink.
SP XCC Series Max Series (HBM)
SP MCC Series