Appendix E: Conguring VROC RAID Settings
201
To Reset the RAID Volume to non-RAID
On the RAID VOLUME INFO submenu shown on the bottom screen of page 199, select the
desired NVMe device from the list of RAID Member Disks and press <Enter> as shown below.
Select Reset to Non-RAID from the screen below and press <Enter> to remove RAID data
from the selected NVMe device.
When the following screen appears, select Yes to conrm that you want to set the selected
NVMe device to non-RAID. The options are Yes and No.
To Next Page
Loading...
