12
i
EN
Obstacle detection
The movement of the belt is monitored. If the roller shutters hit an obstacle in the DOWN
(▼) direction, the belt will stop moving and the belt winder is switched o.
Once the system has switched o, it is no longer possible to directly operate the
drive in the same direction.
◆ Run the belt winder back in the opposite direction and remove any possible
obstacle.
◆ Then it is possible to operate the drive in the original direction again.
There is a risk of injury if the obstacle detection is not working.
◆ The belt must be wound on as evenly as possible to ensure safe and correct
functioning of the obstacle detection function.
◆ Please ensure that the belt winds as straight and evenly as possible into the
device during its subsequent cycle after the obstacle detection system has
triggered.
The superrollo GW60 is an electric roller shutter belt winder designed for use inside. With
its variable installation options, it can either be used as a surface-mounted device or as
a ush-mounted device. The power supply is provided via the enclosed mains adapter.
Features and control options:
◆ Manual operation (MANU)
◆ Automatic mode (AUTO), with a separate switching time for
UP (▲) and DOWN (▼)
◆ AUTO/MANU - switchover
◆ Automatic solar function (dimming when there is sunlight by means of the sun
sensor)
5. Functional description
i
5.1 Description of the safety functions
To Next Page
Loading...
Need help?
General