Superrollo GW60 - Changing or Correcting End Points

35
i
EN
Changing or correcting the end points
5.
Move the roller shutters to the
centre position and congure the
respective end point again.
or
i
11. Manual operation
Manual operation is possible in any of
the modes and has priority over the
programmed automatic functions.
NOTE
◆ The end point settings will be kept
with manual operation.
◆ You can operate the belt
winder for max. 5 minutes at
maximum load. Subsequently
allow the drive to cool for
approx. 30 minutes.
10. Setting the end points
NOTE
After a period of time it may be
necessary to recongure the end
points as the belt may elongate
during the process of operation.
Control
buttons