- 12 -
Follow below steps to connect water supply piper to edger, and fix.
#1 Checking if power of machine is off, power should be cut.
#2 Checking if water supply is closed.
#3 Make sure machine is Place horizontally => regulate 4 screws
under the machine
#7 If the water supply is clogged, check the permeability of the
pipe, especially around the magnetic valve.
#4 Connect the drain piper to the bottom of machine
#5 Connect the water supply pump to running water or pump
#6 If choosing running water, then need to connect to drain piper
#8 Connect the pump or magnetic valve to power.
To Next Page
