Suunto AMBIT - Troubleshooting HR Pairing; Calibrating a POD

TIP: You can also activate the heart rate belt by moistening and pressing both
electrode contact areas.
Troubleshooting: Heart rate belt pairing fails
If the heart rate belt pairing fails, try the following:
●
Check that the strap is connected to the module.
●
Check that you are wearing the hear rate belt correctly (see Section 11.4
Putting on heart rate belt on page 49).
●
Check that the electrode contact areas of the heart rate belt are moist.
14.1 Calibrating a POD
You can calibrate Suunto Bike POD with Suunto Ambit for accurate speed and
distance measurement. Perform the calibration on an accurately measured
distance, for instance, on a 400 m running track.
To calibrate Suunto Bike POD in Movescount, set the bike tire circumference
in Movescount. Movescount calculates a calibration factor. The default
calibration factor is 1.0, which stands for a 26” cross-country bike tire.
71
en