5-6 RECOIL STARTER
REASSEMBLY
Reassembly is the reverse order of disassembly with the special
attention to the following steps.
• Secure the outer end of the recoil spring 6 on the boss in the
reel 1 and wind the spring toward the center of the reel in a
counterclockwise direction.
• Apply the Water Resistant Grease to the recoil spring.
99000-25161: SUZUKI WATER RESISTANT GREASE
• Install the rope 7.
• Install the reel 1 and the recoil spring to the recoil case align-
ing the inner end of the spring with the boss cutaway on the
case.
• Install the ratchet 5 and the spring 4.
Because of the coiled tension in the recoil spring,
wear safety glasses and hand protection when wind-
ing or unwinding the components.
To Next Page
Loading...
