6-22 CHASSIS
•
Apply SUZUKI SUP
ER
GREASE "A"
10
the steering stem
upper and
lower bearings.
For
USA
JifJt
99000-25030: SUZUKI SUPER GREASE "A"
For the
other
countries
JifJt
99000-25010: SUZUKI SUPER GREASE " A"
STEERING STEM
•
Il
gnten me steering stem nut
to
the specilied torque using
the
special tools.
SJ
09940-14911: Steering
nut
socket
wrench
09940-14960: Steering
nut
wrench
socket
(!) Steering stem
nut:
45 N·m (4.5 kgf-m, 32.5 Ib-ft)
•
Turn
th
e stee
rin
g stem lower bracket about five or six times
to
the left and right so that the bearings seat properly.
•
Luu:;,,"
II,,,
:;["",illY
::;1,,",
IIul
1/4-1 /2
of
a
turn
®.
NOTE
:
This adjustm
ent
will vary from motorcycle to motorcycle.
• Tioht
F!n
thp.
!=:.
tAp.ring st
em
head
nut to the specified to
rque.
(!) Steering stem head nut:
90
N·m (9.0 kgf-m,
65
.0 Ib-ft)
NOTE:
Before tightening the steering stem
head
nut
, temporarily install
the front forks.
HANDLEBAR
Wh
en setti
nq
the handlebar clamp
to
the handlebar holder of
the steering upper bracket, face the punched mark
G)
on
its clamp
forward.
•
SO?t
thO?
handlebar
to
match
its
punched
mark
®
to
the
mating
face of the handlebar clamp.
• First, tighten the handlebar clamp bolts @
to
the half
of
speci-
fied torque, and then tighten the handlebar clamp
bolts @
and
(1)
to the specified torque.
(!) Handlebar
clamp
bolt
:
23
N·m
(2
.3 kgf-m, 16.5 Ib-ft)
--
[;~C3
\
http://www.motorcycle.in.th
To Next Page
Loading...
