Suzuki drz 400 2000 - Balancer Shaft

3- 52 ENGINE
BALANCER SHAFT
CD Plate
o Balancer driven gear
Q) Inn er race
C:D Oealiny
® P in
® Balancer shaft
CD Bearing
® Balancer shaft nut
ITEM
I N·m
®
I 50
I kgf -m I
I 5.0 I
Ib- ft I
36.0 I
J ~ 1 :; I
I" ~ . :>~ I r ..
\ "
• When installing the balancer drive gear, align the pin CD with
the groove
@.
•
When installing the bal;mr.p.r (irivgn gear , align the pin @ with
the groove @.
• Install the balancer driven gear by aligning the matching marks.
• Hold the generator rotor using the 26 mm offset wrench, and
then tighten the
balancer shaft nut to the specified tor'l"P
(!) Balancer shaft nut : 50 N·m (5.0 kgf-m, 36 .0 Ib-ft)
http://www.motorcycle.in.th