Suzuki drz 400 2000 - Inspection and Disassembly

• Remove the cushion lever CD and cushion lever rods ®.
INSPECTION AND DISASSEMBLY
SPACERS
• Remove the dust seals. washers and spacers from the
sw in garm and cushion lever.
Inspect the spacers for any flaws or other damage. If any dam-
ages are found. replace the spacers with new ones.
[Aj: AUTION 1
Replace the removed dust seals with new ones .
CHAIN BUFFER
Inspect
the chain buffer for wear and damage. If any damages
are lound.
replace the cnaln butter With a new one.
SWINGARM NEEDLE BEARINGS
Insert the spacers into the needle bearings. move the spacer up
and down and check for any play. If there is excessive play. re-
IJ l cH . .:e lilt! ueGtr illy::; will i II t;!W VJ Ie:;;.
• Remove the swingarm needle bearings using the special tools.
I5tI 09923-74510: Bearing remover
09930-30102: Sliding hammer
I A CAUTiO N]
Replace the r emoved needle beari ngs with new ones.
o
o==-
o
o
o
CHASSIS 6- 37
=0
http://www.motorcycle.in.th