• Hold the generator rotor using a 26 mm offset wrench, and
then remove the
balancer driven gear nut.
• Remove the plate, balancer driven gear, and
key.
• Hold the generator rotor using a 26 mm offset wrench, and
then remove the primary drive gear nut.
• Remove the washer, primary drive gear, pin, key, and bal-
ancer drive gear.
[A CAUTION ]
The
primary
drive
gear
nut
has left-hand threads.
• Hold the generator rotor using a 26
mm
offset wrench, and
then remove the generator rotor nut.
•
Remove
the
generator
rotor using
the
special tool.
ditJ
09930-31921 :
Ro
t
or
remover
N
OTE:
Do not use the rotor remover attachment
to
remove the genera-
tor rotor, since it will
not
fit on the
end
of
the crankshaft. As an
alternative, temporarily install the generator rotor
nut
to
the crank-
shaft,
and
then remove the generator rotor using the special tool.
A
CAUT
ION]
Do
not
hit
the
generator
rotor
with
a
hammer
, other-
wise
the
roto
r may be
damaged
.
• Remove the key
<D
and starter clutch gear @.
ENGINE
3-
19
http://www.motorcycle.in.th
To Next Page
Loading...
