3-
56
ENGINE
• Hold Ihe clutch sleeve hub using Ihe special
1001,
and Ihen
lighlen Ihe clutch sleeve hub nut to the specified torque.
Cib
09920-53740:
Clutch
sleeve
hub
holder
~Clutch
sleeve
hub
nut:
70 N·m (7.0
kgf-m
, 50.5 Ib-ft)
• Bend the tongue of the washer securely.
• Install the spring washer seat
CD
and spring washer ® onto
the clutch sleeve hub correctly.
•
In~t?rt
the
clutch
drive
plates
and
drivQn
plates
ong
by
one
into the clutch sleeve hub
in
the prescribed order.
NOTE:
*
Be
sure
to
install the drive plate with an inside diameter
of
122.5
mm
(4.82 in), first.
*
Two
different types
of
drive plates are used: one with an in-
side diameter
of
122.5
mm
(4.82 in) and seven with an inside
diameter
of
116
mm
(4.5 in). For further information refer to
page 3-55.
• Tighten the clutch spring set bolts securely
in
diagonal stages.
http://www.motorcycle.in.th
To Next Page
Loading...
