7-18
REPAIR
7
Installation
See Figures 7-44 and 7-45.
Figure 7-44
1. Clean cam cover and cylinder head gasket surfaces.
2. Install new gasket (1) to cam cover (2).
Figure 7-45
3. Apply Three Bond™ 1215 to locations (3, 4, 5, and 6)
as shown.
4. Install cam cover and cap screws. (See “Cam Cover
Torque Sequence” on page 7-18.)
Cam Cover Torque Sequence
See Figure 7-46.
Figure 7-46
1. Tighten cap screws (1 through 6) in sequential order
as shown. Torque cam cover cap screws at
increments of 32 lb-in. (3.6 N•m), until specification is
reached.
Cam Cover Cap Screws Torque: 96 lb-in. (11 N•m)
2. Install PCV valve. (See “PCV Valve” on page 7-4.)
3. Install spark plugs. (See “Spark Plugs” on page 7-8.)
4. Install ignition coils. (See “Ignition Coils” on
page 7-8.)
Required Materials
Three Bond™ 1215 (Suzuki PN 99000-1080-15A) or
equivalent
TN0725
1
2
TN0366
3
6
4
5
TN0554
3
4
5
6
1
2
To Next Page
Loading...
