7-36
REPAIR
7
Installation
See Figures 7-84 and 7-85.
Figure 7-84
1. Using bushing, bearing, and seal driver (1), install
new oil seal (2) into front cover (3).
Figure 7-85
NOTE
Install inner and outer rotor as previously marked.
2. Install relief valve (11), spring (10), retainer (9), and
circlip (8).
3. Install inner rotor (4) and outer rotor (5).
4. Install oil pump housing (6) using screws (7). Tighten
to specification.
Oil Pump Housing Torque: 60 lb-in. (6.78 N•m)
Required Tools
Bushing, Bearing and Seal Driver (Suzuki PN
09913-75520) or equivalent
TN0561
1
2
3
TN0557
4
5
6
7
8
11
10
9
To Next Page
Loading...
