Suzuki RM250K4 - Front Brake Master Cylinder Mounting

11
Fit the rubber cover onto the throttle housing.
A: Rubber cover
FRONT BRAKE MASTER CYLINDER
Remove the bolts and holder from the front brake
master cylinder.
A: Master cylinder
B: Holder
C: Bolt
Install the front brake master cylinder onto the han-
dlebars. Align the dot mark on the handlebars with
the master cylinder-to-holder fitting surface. Tighten
the master cylinder mounting bolts to the specified
torque.
"
""
" Front brake master cylinder mounting bolt:
10 N·m (1.0 kgf-m)
A: Master cylinder D: Holder
B: Bolt E: Dot mark
C: Bolt
!
A: Bolt C: Master cylinder
B: Holder D: Handlebars
NOTE:
To install the holder correctly, first tighten the
bolt
B
BB
B of the upper side with specified torque
and then tighten the bolt
C
CC
C of the lower side.
NOTE:
Install the holder in position according to the
mark “UP”.
Make sure that the holder has no clearance at
the upper side as shown.
Check for brake fluid leakage.