23
TIGHTENING THE AXLE HOLDER BOLTS
Extract the stand.
Move the front fork up and down hard 4 or 5 times.
Place the motorcycle on the stand.
Tighten the axle holder bolts to the specified torque.
"
""
" Front axle holder bolt: 18 N·m (1.8 kgf-m)
A: Axle holder bolt
RADIATOR COVER
Install the radiator cover with flange bolt and stepped
washer.
A: Radiator cover
B: 6 × 12 mm flange bolt
C: Stepped washer OD:16.0 mm ID:6.5 mm T:3.5 mm
FUEL TANK VENT HOSE
Install the fuel tank vent hose to the fuel tank cap.
Insert the free end of fuel tank vent hose to the hole
of front number plate.
!
A: Fuel tank vent hose
B: Fuel tank cap
C: Front number plate
D: Hole
Be sure not to bend or twist the hose when
installing.
To Next Page
Loading...
