Suzuki RM250K4 - Front Brake Lever; Throttle Cable

29
REAR/ARRIERE
The procedure to bleed the rear brake is identical to
that of the front.
A: Bleeder valve
FRONT BRAKE LEVER
Remove the lever cover.
Check the brake lever play at the adjuster bolt.
Front brake lever adjuster bolt length:
11–15 mm (0.43–0.59 in)
If adjustment is necessary, carry out the procedure
below:
1. Loosen the lock nut
A.
2. Turn the adjuster
B in or out until the correct
length.
3. Tighten the lock nut
A.
4. Fit the lever cover
C.
THROTTLE CABLE
Check the throttle cable play at the throttle grip.
Throttle cable play: 2.0–4.0 mm (0.08–0.16 in)
If adjustment is necessary, carry out the procedure
below:
1. Loosen the throttle cable adjuster lock nut
A.
2. Turn the adjuster
B in or out until the correct play.
3. Tighten the lock nut
A while holding the adjuster.
4. Place the rubber boot
C.
#
After the adjustment is completed, check that
handlebar movement does not raise the
engine idle speed and that the throttle grip
returns smoothly and automatically.