Suzuki RM250K4 - Crate Removal and Brake Disc Preparation

17
FRONT/AVANT
REAR/ARRIERE
Install the front fender to the front fork lower bracket
as shown in the photograph.
A: Front fender
B: Collared spacer OD:25.0 mm ID:6.5 mm T:6.5 mm
C: Washer OD:28.0 mm ID:6.5 mm
D: 6 × 16 mm flange bolt
E: Front fork lower bracket
Remove the crate axle bracket from the crate base.
A: Crate axle bracket
B: Bolt
1. Lift the front of motorcycle by using a hoist.
2. Raise the rear of motorcycle.
3. Pull the crate base forward, then balance the
motorcycle.
BRAKE DISC
To prevent brake squeaking and pad contamination,
carefully clean the front and rear brake disc plates
with alcohol or other non-petroleum based solvent.
This will remove the rust-preventive coating and dirt.
NOTE:
The bracket and bolt are no longer needed and
may be discarded.