9
Carefully insert the front brake disc plate between the
caliper brake pads.
A: Pads
B: Disc plate
LEFT RIGHT
Attach the spacers to the front wheel hub as shown in
the photographs.
A: Front wheel spacer
LEFT RIGHT
Insert the front axle from the left side of the fork legs.
Place the washer on the right end of the front axle.
A: Front axle
B: Washer OD:20.0 mm ID:12.5 mm
Tighten the front axle nut to the specified torque.
"
""
" Front axle nut: 44 N·m (4.4 kgf-m)
#
A: Axle nut 12 mm
B: Cotter pin L:27.0 mm
NOTE:
The large flange side of the spacer faces the
hub.
Never use force to install the front axle.
If it cannot be installed by hand, it is not cor-
rectly aligned.
Insert the cotter pin through the axle shaft and
bend the ends properly.
To Next Page
Loading...
