Safety and environmental instructions Page 5/33
Programming instructions SYCLOPE ODISEA
®
II. Safety and environmental instructions
The programming you will perform will modify the operation of the controller. For this reason,
it is requested to read these instructions carefully before changing the controller
configuration. Only authorized personnel with suitable training should program the SYCLOPE
ODISEA
®
.
Please:
Read this manual carefully before unpacking, installing or commissioning this equipment
Take into account all the hazards and recommended precautionary measures
Failure to follow these procedures could result in serious injury to users or damage to the
device.
1) Use of the equipment
The SYCLOPE ODISEA
®
system has been designed to measure and control pH and chlorine or
bromine by means of sensors and controls of suitable actuators in the context of the possible uses
described in this manual.
All other uses are considered to be not conforming and must therefore be forbidden. SYCLOPE
Electronique S.A.S. will not be responsible in any case for any damages that result from bad
uses.
2) User obligations
The user undertakes not to allow its employees to work with the SYCLOPE ODISEA
®
equipment
described in this manual unless they:
Are aware of the fundamental instructions relating to work safety and prevention of accidents
Are trained in the use of the device and its environment
Have read and understood these instructions, warnings and functionality
To Next Page
Loading...