Technician Menu Page 20/33
Programming instructions SYCLOPE ODISEA
®
6) Programming of the general timers
Allows programming the various cyclic functions of the controller.
a) Filtering timer
Allows you to control the start-up of the re-circulating motor according to several time intervals,
depending on the week or even depending on the season.
For this function to be performed, it is necessary first to activate it in the configuration management of
the specialist level (see Chapter VII Paragraph 2: Filter timers).
Definition of the operating seasons
It is possible to program the controller to operate in the winter, summer or automatic winter/summer.
For this, it is necessary first of all to define the seasons in automatic mode.
Adjust the summer/winter
cursors to define the start of
the seasons.
Technician level
Langue/Language/…
Set the time
Displays
Histories
Specialist level
Technician code
System date
Setting(s)
Calibrations
General timers
Analogue outputs
Specialist level
Technician code
System date
Setting(s)
Calibrations
General timers
Analogue outputs
General timers
Filtering
Flocculant
Printing
Storage rate
General timers
Filtering
Flocculant
Printing
Storage rate
Filter cycles
Seasons
Weeks
Timers
Circulating cycles
Seasons
Weeks
Timers
Cycles of the seasons
Automatic
Summer
Winter
Cycles of the seasons
Summer
Winter
To Next Page
Loading...