Technician Menu Page 21/33
Programming instructions SYCLOPE ODISEA
®
► Select automatic mode for filtering to operate in winter and summer mode according to the
programmed seasons.
► Select "Summer" mode for filtering to operate only in summer according to the
programmed cycle of seasons.
► Select "Winter" mode for filtering to operate only in winter according to the programmed
cycle of seasons.
Definition of the number of filtering weeks
It is possible to define the filtering cycles over several weeks with different time intervals. For example,
a filtering cycle can take place over 8 weeks with different time intervals for each week.
Define the number of filtering weeks
Definition of filtering time intervals by weeks
This is a question of defining the operating time intervals according to the season, week and days of
the week. It is possible to set up to 8 timers.
Set the operating time interval
and the days of the week on
which this interval is applicable.
In the example above, timer 1 is set to activate the filtering from 9 am to 6 pm on Monday, Tuesday,
Wednesday, Thursday and Friday of week 1.
► Follow this same process to set all the desired timers for the summer season.
► Follow this same process to set all the desired timers for the winter season.
► Activate the "Reset timers" line to delete all the recorded timers.
To control the filter motor, the user must program an available relay of the motor in order to
activate the motor (see Chapter VII Paragraph 2: Prog. relays).
Filter cycles
Seasons
Weeks
Timers
Week cycles
Current week: 1
Duration (weeks): 8
Cycles filtration
Saisons
Semaines
Timers
Season cycles
Summer
Winter
Reset timers
Set timer 1
On: 9:00 am Off: 6:00 pm
M T W T F S S S:1
To Next Page
Loading...