11
GO User Guide
Swivel jack:
Use the swivel jack to safely disconnect the GO (coupler) from the tow vehicle. Once
disconnected, the swivel jack allows you to easily push the GO into desired location. The
swivel jack is connected to the tongue with a spring-loaded mount. By pulling out the curved
metal release handle, you can free the swivel jack and allow it to rotate and lock into vertical
position. By turning the top plastic handle you can raise and lower the GO on and off the
coupler and also use to level the GO front to back.
Coupler connect/disconnect:
To connect and disconnect the standard 2” ball coupler, simply grab the coupler handle,
squeeze the trigger and lift up. With handle raised, lower the coupler down onto the hitch
ball. The indicator graphic on the left side of the coupler shows if the coupler is engaged, the
positive zone indicates that the coupler is secured, the negative zone indicates that the
coupler is not secured.
For additional details on the coupler connect/disconnect, please watch GO tutorial videos on
our website and/or YouTube channel.
Secure removable tailgate:
It is extremely important that the removable rear tailgate is secured to the bed platforms by
using the 24” long velcro strap, to prevent damage while traveling. Wrap the velcro strap
around the bed platforms and the tailgate and secure, before driving.
Secure ring grip pins:
Before traveling, be sure all (4) ring grip pins are inserted into the proper locations on the
rack, (note: by raising the lift system very slightly, you can further lock them into position).
For additional details on the coupler connect/disconnect, please watch GO tutorial videos on
sylvansport.com/go-owners, or our YouTube channel.
To Next Page
Loading...