sylvansport GO - Troubleshooting and FAQ (Continued); Q: Why is Grease Coming Out of Wheel?; Q: Why is There Water in My Tent?; Q: Why Are My Trailer Lights Not Working?

47
GO User Guide
Q: Why is grease coming out of wheel?
A: There is excess grease or the rubber seal has been blown. Clean up the area and replace
the seal.
We strongly recommend you repack the bearings and replace the seals every 10,000 -
12,000 miles.
We use Dexter axles, additional information on Dexter axle parts can be found on their web-
site. dexteraxle.com.
Q: Why is there water in my tent?
A: Condensation can occur without proper ventilation. Keep bottom vents open and front
door zipper and/or window open when possible, and remove table panels from attic. If you
see active water intrusion, please contact SylvanSport customer service for repair/
replacement options.
Q: What if one of my tent poles bends severely or breaks?
A: The pole will need to be replaced. Be careful not to pinch when taking down or setting up.
Call SylvanSport customer service at (828) 393-4927 or visit sylvansport.com, to order a
replacement.
Q: Why are my trailer lights not working?
A: If lights aren’t working, rst use a 4-pin tester to check the wiring on the tow vehicle. If the
tow vehicle is working properly, the issue is likely with the GO. Bring your GO to an RV
technician/mechanic to diagnose the electrical system.
Q: Why can’t I get the table panels down?
A: Be sure nothing is on top of panels, the latch is unhooked, and the holes of the two panels
are properly aligned before pushing up to release and ip bar. If mattresses are stored above
panels, be sure they are deated.
Q: What do I do about a stabilizer jack that is stuck in the lowered position?
A: Use a dry lubricant spray if available. For the rear stabilizer jacks, try lowering the swivel
jack to relieve pressure. For the front stabilizer jacks, try raising the swivel jack, to relieve
pressure. Check that the jack has not been damaged or bent due to adjustment rod not
passing through both holes. If necessary, replace the jack. Always be sure stabilizer
adjustment rod passes through both holes to prevent bending and damage.
Q: Why are my vestibule zippers not compatible with my awning?
A: You may require a zipper adapter. Please contact SylvanSport customer service.
For more FAQs and more detailed answers, please visit sylvansport.com/go-owners