49
GO User Guide
If the cable has not jumped outside of the spool and appears to be bound on itself:
1. Raise the tent pod assembly to the fully raised position,
open the pod assembly and drop the pod bottom down and
into fully vertical position. Using the crank handle, lower
the tent pod assembly so the bottom is resting on the deck.
This will lock the assembly and provide a “safety jack” to
ensure the tent pod assembly won’t fall while working on
the winch).
2. Turn the crank handle counter-clockwise on full turn to
relieve tension on the spool. Observe the spool and locate
the location of the bind in the cable.
3. Using a at head screwdriver and a twisting motion, relieve
tension at the bind in the spool. DO NOT USE FINGERS TO
ATTEMPT CABLE UNTANGLING.
4. Once loose, unspool cable completely, or until the bind in
the cable is gone.
5. While keeping tension on the cable, respool cable back
onto spool.
6. Raise tent pod assembly fully, close and latch the bottom
of the tent pod. Lower the tent pod assembly.
If you have any questions, please contact SylvanSport
customer service by calling (828) 393-4927
To Next Page
Loading...