Sym FIDDLE 125 User Manual

14. STEERING/FRONT WHEEL/FRONT SHOCK ABSORBER SYM
14-2
PRECAUTIONS IN OPERATION
General Information
 Before remove front wheel, use a jack to lift the body until front wheel free of ground, and
take care not to rotate body in reverse.
 Be careful not to allow oil or grease get on brake drum or linings.
Torque values
Front wheel axle 5.0~7.0kgf-m
Steering handlebar nut 4.0~5.0kgf-m
Steering column top cone sliding ring 0.2~0.3kgf-m
Steering column lock nut 1.0~2.0kgf-m
Speedometer cable nut 0.15~0.3kgf-m
Front shock absorber: Upper nut 2.4~3.0kgf-m
Tools
Special service tools
Steering column wrench
Bearing remover
Inner type bearing remover
Attachment, 32×35 mm
Attachment, 42×47 mm
Steering column nut wrench
Steering column top cone ring nut wrench
TROUBLE DIAGNOSIS
Hard steering stem
 Over tightening of steering stem lock nut
 Broken steering stem steel ball and cone
bearing seat
 Insufficient tire pressure
Steering stem off center
 Uneven left/right cushion
 Bend fork
 Bent front wheel/tire offset
Front wheel wobbling
 Deformed rim
 Front wheel bearing loose
 Faulty tire
 Wheel axle nut tightened improperly
Soft front suspension
 Weak fork springs
 Oil leakage of the shock absorber seal
Front suspension noise
 Cushion cover friction noise
 Cushion bolts loose

Sym FIDDLE 125 Specifications

General

Displacement	124.6 cc
Cooling System	Air Cooled
Transmission	CVT
Front Suspension	Telescopic Fork
Front Brake	Disc
Rear Brake	Drum
Front Tire	110/70-12
Rear Tire	120/70-12
Seat Height	780 mm
Engine Type	4-Stroke
Fuel Tank Capacity	6.5 L