16
§DISK BRAKE INSPECTION§(Applicable for model equipped with disc brake.)
Visual check brake lines for leakage, or damage, check
brake lines connections for looseness using a wrench or
similar tool, and check whether steering handle vibration in
driving, or any parts’ interference may have damage the
brake lines. If so, bring your scooter to your SANYANG
dealer for repairing or service.
（leak, damaged, looseness of brake line）
(Checking front brake lining)
check the brake from behind the brake
caliper. The brake pad must be replaced
with new lining when the brake pad wear
limit reaches the brake disk.
(Checking oil quantity in brake oil reservoir)
Park the scooter on a lever ground, and
check if fluid lever is under the “LOWER”
mark. Recommended Brake Fluid: WELL
RUN BRAKE OIL (DOT 3).
(Replenishment of front wheel brake fluid)
1.Loosen the screws and remove the master cylinder cover.
2.Wipe clean foreign materials, dirt around the reservoir, being
careful not to let foreign materials fall into the reservoir.
3. Remove the diaphragm plate and the diaphragm.
4. Add brake fluid to upper lever.
5.Install the diaphragm plate and the diaphragm, and install the
master cylinder cover.
6.please note the diaphragm direction, and do not let foreign
materials fall into the reservoir. And tighten the master
cylinder cover securely.
To Next Page
Loading...
Need help?
General
