9
Seat open
Turn ignition switch to the“ON” position and press this button down. Then, the seat will
be open.
This button will return to original position after
releasing.
Press the seat down and it will be locked
automatically.
After the seat catch has been locked , check to make
sure it has locked properly by lightly lifting the seat.
Engine start control switch
The switch button position is under seat.
“ON” position: Engine is locked and cannot be started
engine in this position.
“OFF” position: When the ignition switch is “on” position,
the start control switch is “off” position, press
electrical starter button while holding the front
or rear brake lever will start the engine.
Horn Switch
Press this button down when ignition switch is in the “ON” position, the horn will sound.
Turn Signal Switch
Turn signal lights are used when turning left/right or changing lane.
Turn ignition switch to the “ON” position, and slide the turn signal switch to left or right . Then, the
turn signal lights will flash.
To release, simply return the turn signal light button to the original position.
Left-side turn signal light flashing means you intend to make a left turn.
Right-side turn signal light flashing means you intend to make a right turn.
§STORAGE BOX§
This box is located under the saddle.
Maximum load capacity:10kg.
Do not store valuables in the box.
Make sure that the saddle has been locked completely
after it was pressed down.
Take out valuables before washing to avoid wetting these
objects.
Do not place thermal sensitive objects in the box
because of engine’s heat and high temperature.
CAUTION:
Be sure to remove the key after the seat
has been locked.
Do not put the key inside the storage
box after unlocking to avoid the key being
locked inside the storage box when the
seat is pressed down automatically.
To Next Page
Loading...
Need help?
General
