7.
USE OF EACH COMPONENT
(The following is SYM 4 stroke air-cooling50c.c/125c.c./200c.c. scooter’s basic operation,
and they could vary from different individual models. Please consult the end of this
manual.)
§GAUGES §
Speedometer/ Tachometer：
Indicates driving speed or engine rpm.
In voltage display status , press the "MODE"
button for more than 2 seconds, it can
switching over speedometer/engine
tachometer display.
When dial plate display driving speed, the
lower LED screen display engine rpm, after
switch instead.
When dial plate display engine rpm, the lower
LED screen display driving speed.
Odometer：
Indicates total accumulated distance traveled.
Trip Kilometer:
The rider can measure the trip kilometers.
In normal display status, press “MODE”
button for 1second,it can show total distance
traveled.
Press “MODE” button again, then it can
switching over trip kilometer display mode.
In trip kilometer display status, press "SET"
button for a long time, it can eliminate the
mileage value.
High Beam Indicator：
This indicator comes on with high beam
headlight is turned on.
Turn (left/right) Signal Indicator：
The left or right Indicator will be flashing
according to the operated directions of turn
signal light switch when it is turned on.
Fuel Meter:
The pointer in this meter shows how much
fuel remains in the tank.
The pointer stays in “E” position when key
switch is turned to “OFF”.
Voltmeter/time:
Display average voltage of battery or time.
Under the normal display status, press
"SET" button 0.5 second, it can switch
“VOLTAGE” display mode or “CLOCK”
display mode.
In time display mode, when the scooter is
stationary , long press the "MODE" button
more than 2 seconds, then it enter the time
setting MODE, at this time press “MODE”
button 1second, it can switching over
setting mode(Hour→minutes tens digit→
To Next Page
Loading...
Need help?
General
