Symantec NetBackup 5230 - Page 175

Table 12-5 lists all the error messages, displayed on the Manage > Storage tab.
Table 12-5
Manage > Storage
Recommended actionExplanationError messages
Please contact Symantec Support.
Warning: This is non-recoverable error. You
need to collect all the Vxul logs using the
DataCollect command and share them
with the Symantec Support team to debug the
error.
This error can be displayed
due to the following reasons:
■ This message appears if
appliance storage
component is not able to
fetch any partitions, disks,
and distributions.
■ This message can also
appear if the connection
between the appliance
core and the NetBackup
Appliance Web Console is
lost.
Failed to fetch storage information.
You cannot select the same disk name, select
a different target disk than source.
This message can appear
when you perform the Move
Partition operation. It occurs
if you select the same disk
name in the From and To
drop-down lists.
Source and target disks are same.
Enter a name that is lesser than 256
characters.
This message appears in case
there is an error in the
provided name for a storage
unit or a disk pool.
The maximum length is 256 characters.
Remove the following special characters from
the storage unit or disk pool name:
`~!@#$%^&*()=|\\\"\':;<,>,?/
This message appears in case
the provided name for a
storage unit or a disk pool
contains following characters:
`~!@#$%^&*()=|\\\"\':;<,>,?/
The following characters are not
allowed: in the storage unit and disk
pool name
Table 12-6 lists all the error messages, displayed on the Manage > Host tab.
175NetBackup Appliance error messages
Error messages displayed on the NetBackup Appliance Web Console