Synesso MVP Series

59
PROGRAMMING
Menu Level 3: Conguraon
See the previous page for instrucons on how to access menu level 3.
This is the conguraon screen.
Pressing a line buon will ash the rst adjustable value. Pressing it again will ash the next, and so on.
Model codes: H = MVP Hydra, S = MVP Single pump, C is not used at this me.
Bypass and boost values should reect whether or not the machine has the appropriate hardware installed,
not whether they are being used. Since bypass hardware is only compable with Hydras, the value will
change to “N” if the model value is not “H”
The serial number entered on this screen is shown during the machine boot-up sequence.
If any sengs on this screen are changed, the machine will require a restart upon exing this screen. When
prompted, press the corresponding line buon to restart or to cancel and revert to the previous sengs.
Machines with rmware version 2.62 and above will display the Conguraon screen as in the picture
above. This updated conguraon includes model SX0 for the S-Series machines.
Line 3 includes PRG for the purge funcon which is a standard funcon of S-Series machines only. For MVP
Series, PRG should be programmed as “N”.
To cycle to the next display screen or to lock in changes and restart, press the down buon.