Need help?Do you have a question about the System Sensor PDRP-2001 and is the answer not in the manual?
General| Model | PDRP-2001 |
|---|---|
| Type | Fire Alarm Control Panel |
| Maximum Number of Zones | 2 |
| Operating Temperature | 32°F to 120°F (0°C to 49°C) |
| Power Supply | 120 VAC, 50/60 Hz |
| Humidity | Up to 93% RH, non-condensing |
| Compatibility | System Sensor devices |
Lists key features of the PDRP-2001 control panel, including IDCs, output circuits, relays, and optional modules.
Details technical specifications for AC power, battery, initiating device circuits, notification appliance circuits, and relays.
Provides instructions for securely mounting the control panel's backbox to a wall, including predrilling and securing steps.
Details primary AC power source and earth ground connections, including wiring requirements and safety precautions.
Explains that the FACP is field programmable using the keypad and introduces program templates for typical configurations.
Describes the two factory set programming passwords and how to access programming or read status modes.
Details how to enter the master programming level, which enables full control over panel configuration and features.
Allows selection of factory preprogrammed templates or custom templates for quick panel configuration.
Guides the user through programming or changing the configuration for the six input zones (circuits).
Explains how to configure the four output circuits, including enabling, type selection, and coding options.
Guides on calculating the total AC current required for the system, including wiring and protection requirements.
Details how to calculate primary, secondary, and standby current draws for system power supply and battery sizing.
Provides steps to calculate the required battery size (AH) for standby and alarm conditions based on NFPA requirements.
Covers initial system testing procedures, including inspection, alarm tests, and detector testing after installation.
To Next Page
