Nano ITC Getting Started Guide Page 17
Chapter: 2
Installing the Nano ITC
Unpacking/Repacking the Nano ITC
CAUTION: To avoid mistakes, read this entire chapter before you begin installation.
The instructions needed to unpack and repack the instrument are found as separate unpacking instructions
in the shipping box and in the online documentation associated with the instrument control software. You
may wish to retain all of the shipping hardware and boxes from the instrument in the event you wish to
repack and ship your instrument.
Installing the Instrument
Before shipment, the instrument is inspected both electrically and mechanically so that it is ready for oper-
ation upon proper installation. Only limited instructions are given in this manual; consult the online
documentation for additional information. Installation involves the following procedures:
• Inspecting the system for shipping damage and missing parts
• Connecting the Nano ITC to the TA Instruments controller computer
• Connecting USB cables
It is recommended that you have your Nano ITC installed by a TA Instruments Service Representative; call
for an installation appointment when you receive your instrument.
Inspecting the System
When you receive your instrument, look over the instrument and shipping container carefully for signs of
shipping damage, and check the parts received against the enclosed shipping list.
• If the instrument is damaged, notify the carrier and TA Instruments immediately.
• If the instrument is intact but parts are missing, contact TA Instruments.
WARNING: Do not attempt to unpack this instrument alone.
To Next Page
Loading...
Need help?
General
