TA Instruments TGA 2050 User Manual

Installing the TGA 2050
2–26 TA I NSTRUMENTS TGA 2050
9. Locate the tare hang-down wire in your
accessory kit.
10. Hold the wire in your hand so that the
doubly bent top hook is pointing to the left
and the bottom hook is pointing to the right.
11. Using brass tweezers, insert the tare hang-
down wire into the balance chamber on the
tare side and down through the hole above
the tare tube connection, taking care not to
bend the wire.
12. Being careful to keep the top hook pointing
to the left, pass the double bend through the
hang-down loop so the wire is hanging from
the loop.
13. Select the sample pan you will use in your
experiments and load one of the same size
and type onto the tare hang-down wire.
14. Replace the tare tube and finger-tighten it to
compress the O-ring seal.
You are now ready to align the hang-down
wires.

TA Instruments TGA 2050 Specifications

General

Brand	TA Instruments
Model	TGA 2050
Category	Measuring Instruments
Language	English