TB9400/TN9275 Installation and Operation Description 13
© Tait International Limited May 2023
The WebUI Monitor > Modules > Module Details tab also lists the Series
number and hardware version of the reciter:
1.1.2 New Reciters and Repairs
Tait only provides new and replacement series 2 reciters. There is no
further production of series 1 reciters. Repairs needing a new control board
will also use a series 2 control board.
Using Series 2
Reciters in an
Existing Channel
Group
If you are adding a new or replacement reciter, Tait strongly recommend
that all the existing series 1 reciters be upgraded to version 3.10 or later, so
that all the reciters in the channel group have the same firmware version.
Failure to do so may lead to problems with channel group operation.
Reciter Repairs
Needing a
Replacement
Control Board
Series 1 reciter repairs needing a new control board will be returned as
series 2 reciters running version 3.10 or later firmware. Returned
equipment will include a notification sticker that this reciter is now series
2 and warns of possible channel group compatibility issues with reciters in
the network running older firmware.
1.1.3 Firmware Information
There are separate firmware packages for series 1 and series 2 reciters as
they run different processors.
To Next Page
Loading...
Need help?
General
