14 Description TB9400/TN9275 Installation and Operation
© Tait International Limited May 2023
Upgrading version 3.05 or earlier from a feed server will display 2 versions
for version 3.10 and later. The version ending in ‘-02’ is series 2 reciter
firmware:
Attempting to download -02 firmware to a series 1 reciter will fail, with a
status of ‘Error’ within a few seconds.
Upgrading from a feed server with a reciter running version 3.10 or later
will select the correct firmware package for the reciter automatically. The
list of firmware presented in the lower section is filtered by the P25/AS-IP,
DMR/MPT or All radio buttons at the top of the Tools > Firmware >
Upload/Download tab WebUI page.
If you are using the direct firmware upload option, the series 1 firmware
file has the suffix
.tbc and series 2 has the suffix .tbc02. File selection
has a filter for the correct file extension.
Uploading the incorrect firmware version for the series of reciter will fail
with the message ‘Information Failed Configuration’ in the Direct upload
section.
Refer to the latest software release note for series 2 hardware and firm-
ware compatibility information.
1.2 Firmware Applications
The TB9400 is interoperable with both TB7300 and TB9300 base stations,
and therefore operates in both P25/AS-IP and DMR/MPT networks.
1.2.1 Base Station Features
The following are lists of base station features available in both P25/AS-IP
and DMR/MPT firmware and non-specific applications:
To Next Page
Loading...
Need help?
General
