To Next Page

To Previous Page

TB9400/TN9275 Installation and Operation Operation 49

Display

The display is used in conjunction with the keypad to access the base

station’s menus. It allows the technician to configure the IP address of each

reciter (refer to “Setting the IP Address” on page 92), and to set the contrast

of the display (see below).

After the base station is powered up, the display shows “Please wait...”

while the base station is starting up, followed by the home screen when the

start-up process is complete. The home screen shows four lines of user-

defined text, which can be entered via the WebUI (Identity > Identity >

Base Station > Front panel message).

From the home screen press an arrow key, a scroll key or OK to go to the

base station menu. The display returns to the home screen from any other

screen 30 seconds after the last key press. Press any key to turn on the

backlight. The backlight turns off 30 seconds after the last key press.

If the keypad has been disabled, pressing an arrow key, a scroll key or

OK will cause the display to show “Keypad Disabled”.

Set the display contrast as follows:

1. From the base station menu select Modules > Front Panel > Contrast.

2. To increase the contrast, press the right arrow or scroll up key. To

decrease the contrast, press the left arrow or scroll down key.

When the contrast is set to the required level, press OK to save the changes

and exit the menu.

Menu Map The menu map below shows the menu items available in this release of the

base station.

Notice The menu map shown is for a single base station. The menu

items available in your base station will depend on which modules are

present in the subrack, and whether the keypad has been disabled.

Tait TB9400 User Manual

Other manuals for Tait TB9400