66 TMAA10-02 Handset TM8000 Mobile Radio Accessories Manual
March 2004 © Tait Electronics Limited
7.2 Interface Specification
The following table and diagram summarizes the signals used for the handset
on the radio’s microphone connector and shows the interface between the
handset and the radio.
.
Table 7.4 Handset microphone connector - pins and signals
Pin Signal
Handset PCB
Connector
Colour Description
1 RX_AUD 8 brown receive audio to handset
2 —— —not connected
3 —— —not connected
4 PTT 2 white PTT and hookswitch
5 MIC 9 yellow audio from the handset to dynamic-mic
support board
6 GND 10 green analogue ground
7 —— —not connected
8 CH_GPIO1 3 blue programmable line controlling private mode
Figure 7.2 Handset to radio interface
To Next Page
Loading...
