8 Troubleshooting
100 TW9
Fault Possible cause Remedy
8.12 Decrease in machine's performance (loader installation)
1 Insufficient engine power Check diesel engine and adjust if necessary
2 Hydraulic oil level too low Top up hydraulic oil to mark on dipstick
3 Pump is sucking up air Re-tighten hose connections. Replace O-ring or
seals
4 Insufficient operating pressure Re-adjust main pressure relief valve, replace if
necessary
5 Pump worn Replace pump
6 Incorrect hydraulic oil Quality of hydraulic oil must conform to our
recommendation
8.13 Working cylinders not operating satisfactorily
1 Seals in cylinders worn Re-seal cylinders
2 Secondary valves defective Check secondary valves and replace completely if
necessary
8.14 Faults in the electrical system
1 Outside and/or internal lighting damaged Check cables, connections, bulbs and fuses
2 Windshield wiper not working Check cables, connections, and fuses
Examine windshield wiper for mechanical damage
Check or replace if necessary
3 Horn not responding Check cables, connections, and fuses
Replace complete horn if required
4 Control organs are imprecise Determine the fault or source of the problem, call
Service Agent if necessary
5 Starting system does not work
satisfactorily
Check charge capacity of battery
Test starter function
Check connection and condition of power and
battery ground cables
Check function of ignition lock, replace if
necessary
To Next Page
Loading...
General