Operation 4
TW9 43
4.3.2 Monitoring during operation
If the engine and the machine are put
into operation without prior remedy of
the defect, severe damage to the engine
may result!
• If the battery charge control lamp (12/22) or the
engine oil pressure indicator lamp (12/31) light
up, switch off the engine immediately and
determine the cause, or call for service
personnel.
• If the permitted engine oil temperature (12/25)
is exceeded, stop work, open the engine hood
and keep the engine running at idle speed to
allow it to cool down.
Once the engine has cooled down, turn it off
and determine the cause of overheating, or call
for service personnel.
• If the air filter service indicator lamp (12/32)
lights up, perform the necessary air filter
maintenance.
4.3.3 Switching off the engine
Do not switch off the engine when
running at full throttle, but allow it to run
for a short time without load at low idle-
running speed.
• Turn the ignition key to "0". The engine stops
automatically.
22
25
31
32
L824-012
Fig. 12 Operation
To Next Page
Loading...
General