Technical data 3
TW9 29
3.9.2 Consumable specifications
Stipulated consumables for Central Europe
Application Designation
Specification, standards,
quality
Remark
Engine Diesel fuel EN 590
ASTM D975 1-D / 2-D
Before using RME fuels (rape oil methyl
ester), it is essential that you consult your
responsible dealer for further details.
Engine Engine oil SAE 15W-40
API CH-4 or CI-4
ACEA E3 / E4
See also engine manufacturer’s instructions
Hydraulic system
Hydraulic oil or
multi-grade
engine oil
HVLP 46
or
SAE 10W-40
The following viscosity limit values must be
observed (according to ASTM 445)
at 100°C min. 8 mm
2
/s (cSt)
at -10°C approx. 1,500 mm
2
/s (cSt)
Bio-degradable
hydraulic oil
based on
synthetic ester
Filling according to customer
specifications. Brand label on
machine.
Do not mix bio-
degradable oils from
different manufacturers.
The same viscosity values apply as for mineral
hydraulic oils.
When changing from mineral to bio-
degradable hydraulic oils, the tank and
hydraulic system must be completely drained,
cleaned, and flushed.
For further details, please consult your
responsible dealer before changing oils.
Axles Transmission oil SAE 85W-90LS
API-GL 5
Alternative recommendations
SAE 90LS
SAE 80W-90LS
Lubrication points
Multi-purpose,
lithium-soap
based grease
K2K-30
DIN 51825
Brake Brake oil ATF
Type A Suffix A
Dexron-IID
Cooler
Mixture of water,
additives and
glycol
Machine damage
due to incorrect coolant
and mix proportions.
Observe the cooling
system information
provided in the engine
manufacturer's
Operating and
Maintenance Manual.
The antifreeze is factory-set to approx. -25°C.
To Next Page
Loading...
General