Takeuchi TW9 - Brakes

7 Maintenance and Care
86 TW9
7.9.8 Brakes
Checking the brake oil level
• Visual inspection (49/1) of brake oil level.
Only top up with ATF-oil!
Changing brake oil and bleeding the brake
Collect the waste oil, do not allow it to
seep into the ground.
Dispose of according to regulations!
Use a bleeding device for changing
brake oil and bleeding.
• Remove the cover on the front-end above the
axle.
• Release the bleeder screw (50/1), connect the
bleeder hose and insert it into collecting bottle.
• Connect the bleeding device to the brake oil
container (49/1).
• Change brake oil and bleed the brake
according to the Bleeding Device Operating
Instructions.
• Remove the bleeder hose and re-tighten the
bleeder screw.
• Release the bleeder screw (50/2) on the inch
valve of the "travel" hydraulic pump; connect
the bleeder hose and insert it in the collecting
bottle.
• Perform the bleeding process.
• Remove the bleeder hose and re-tighten the
bleeder screw.
• Dismount the bleeding device and close the
brake oil container using the original cover.
• Re-mount the cover on the front-end.
1
L824-049
Fig. 49 Brake oil
1
Fig. 50 Venting the brake