ADDING IP PHONES TO TALKSWITCH 11
7. The phone will request you reboot the phone. Press the Yes softkey to initiate the reboot.
It should take no more than 1 minute for boot process to finish. During this process, the
phone contacts the TalkSwitch unit, which automatically registers and configures the
phone. When complete, the phone will display the extension name and extension number.
The phone is now ready for use.
If registration does not work
If the IP phone is not successfully registered and configured, perform the following steps. On
the phone:
1. button (TS-350i) / button (TS-450i, TS-550i).
2. Press 6 to enter the default all settings menu.
3. Press the Yes softkey to default the settings.
4. Press the button (TS-350i) / button (TS-450i, TS-550i) to exit the menu.
5. The phone will request you reboot the phone. Press the Yes softkey to initiate the reboot.
It should take no more than 1 minute for boot process to finish.
6. If setting up an external IP extension, follow the steps in Programming the TalkSwitch IP
phone as an external IP extension after the phone reboots.
7. Contact your reseller or TalkSwitch Customer Support if registration is still unsuccessful.
To Next Page
Loading...
