Talkswitch TS-9133i - Programming the Talkswitch IP Phone as an External IP Extension

ADDING IP PHONES TO TALKSWITCH 17
3. Optionally, you can apply predefined key assignments from a template file using the Open
Template button. See Using a key assignment template on page 8.
If necessary, use the Default button to restore the keys to their default settings.
4. Your key assignments can be saved as a template for programming additional phones. See
Saving a key assignment template on page 8.
Programming the TalkSwitch IP phone as an external IP extension
If you are setting up an external IP extension, you must ensure there is a communication path
over the network between your phone and your TalkSwitch system. See Configuring the router on
page 2.
Program the following settings into the phone. On the phone:
1. Press the Options key.
2. On the TS-9133i or TS-480i, navigate to the Network Settings menu, then press Enter
or Show. On the TS-9143i, navigate to the Admin menu, then press Enter.
3. Enter the password. By default this is 22222. When the TalkSwitch unit configures the
phone, it changes the password to 23646 (which spells “admin” on the telephone keypad).
4. On the TS-9133i or TS-480i, navigate to the TFTP Settings menu, and then press Enter or
Show. On the TS-9143i, navigate to the Config Server menu and press Enter, then select
TFTP Settings and press Enter.
5. Select Primary TFTP, and then press Enter or Show.
6. Use the keypad to enter the public IP address of the TalkSwitch system, then press Set or
Done.
7. Reboot the phone. After a short delay, the phone will indicate it is initializing the network,
checking for firmware updates, and following automatic programming steps. During this
process the phone contacts the TalkSwitch unit, which automatically registers and
configures the phone. When complete, the phone will display the extension name and
extension number. The phone is now ready for use.