ADDING IP PHONES TO TALKSWITCH 18
If registration does not work
If the IP phone is not successfully registered and configured, perform the following steps.
On the TS-9133i or TS-480i phone:
1. Press the Options key.
2. Use the cursor keys to navigate to the Phone Status menu, then press Enter or Show.
3. Use the cursor keys to navigate to the Restore Defaults menu, then press Enter or Show.
4. Enter the password. By default this is 22222. When the TalkSwitch unit configures the
phone, it changes the password to 23646 (which spells “admin” on the telephone keypad).
5. Select All Defaults, then press Enter or Show.
6. Press # to confirm that you want to restore defaults.
7. If setting up an external IP extension, follow the steps in Programming the TalkSwitch IP
phone as an external IP extension after the phone reboots.
8. Contact your reseller or TalkSwitch Customer Support if registration is still unsuccessful.
On the TS-9143i phone:
1. Press the Options key.
2. Use the cursor keys to navigate to the Admin menu, then press Enter.
3. Enter the password. By default this is 22222. When the TalkSwitch unit configures the
phone, it changes the password to 23646 (which spells “admin” on the telephone keypad).
4. Navigate to the Factory Defaults menu, then press Enter.
5. Press # to confirm that you want to restore defaults.
6. If setting up an external IP extension, follow the steps in Programming the TalkSwitch IP
phone as an external IP extension after the phone reboots.
7. Contact your reseller or TalkSwitch Customer Support if registration is still unsuccessful.
Further configuration
The steps above will configure your TalkSwitch IP phone and will enable the programmable keys.
Click the Local Extension/Fax Help icons for instructions on configuring direct line access,
hunt group permissions, Caller ID settings (VoIP only), call handling, and voicemail.
For phone-specific configuration, refer to your phone user guide.
Contact your reseller or TalkSwitch Customer Support if you require further assistance with
special ports or network settings.
To Next Page
Loading...
