To Next PageTo Next Page
Need help?Do you have a question about the Tarot 600 and is the answer not in the manual?
Explains warning, caution, and forbidden symbols used in the manual.
Highlights that R/C helicopters are not toys and emphasize safety and user responsibility.
Advises choosing a legal, open, and smooth flying field for safety.
Warns about Li-Po battery volatility and need for following instructions.
Stresses keeping model away from moisture to prevent malfunctions.
Advises using genuine parts and correct operation for safety.
Recommends seeking help from experienced pilots for assembly and first flight.
Advises operating within ability and never leaving model unattended.
Warns about rotating blade danger and maintaining safe distance.
Advises storing model away from heat sources to prevent damage.
Lists necessary tools like Swashplate Leveler, Pliers, and Ball Reamer.
Details crucial pre-flight safety checks for operational readiness.
Instructs on cutting motor, ESC, and battery wires to specified lengths.
Explains how to cut ESC covers based on different ESC models.
Covers securing ESC wires, organization, and anti-slip sticker application.
Details assembly of main rotor holder, including bearings and thrust bearings.
Guides on installing damper rubbers, mentioning hardness for flying styles.
Describes installation of the feathering shaft and its components.
Details assembly of control arm and CCPM swashplate with linkage balls.
Shows the 0-degree pitch maker for setting rotor pitch.
Describes assembly of elevator linkage and installation of the main shaft.
Shows installation of washers and screws for the main shaft assembly.
Guides on connecting signal lines, servo wiring, flybarless, main gear, and anti-static lines.
Guides on assembling motor mount and installing the motor.
Shows installation of the 12T motor pinion gear.
Illustrates assembly of pressure gear set and installation of servo plate.
Details assembly of linkage rod (E) and routing of tail servo wiring.
Illustrates securing frame parts with locknuts.
Shows mounting servos and securing servo lines with cable ties.
Details installing motor mount plates and bearings into the frame.
Illustrates installing metal columns for structural support.
Emphasizes not fully tightening motor mount screws initially.
Guides main shaft insertion, bearing setup, and linkage rod/servo assembly.
Shows main shaft ring, helical gear, and anti-rotation bracket assembly.
Illustrates installing the lifting arm connecting rod ball.
Shows the battery lock button.
Guides on installing main shaft fix ring and helical gear set.
Illustrates attaching components to carbon fiber frame and installing metal columns.
Shows servo mount details and guides tail servo set installation.
Details tail servo fixing and tail boom belt installation.
Shows tail belt diagram and guides tail rotor holder assembly.
Advises thrust bearing inspection and tail shaft pin alignment.
Details tail control guide and vertical stabilizer installation.
Advises leaving servo arms unpowered for adjustment during trim flight.
Guides on installing tail brace pushrods and horizontal stabilizer.
Shows device installation diagram and guides cover installation.
Details the installation of the receiver antenna mount.
Guides motor gear meshing and tail gear box assembly.
Instructs on neatly arranging ESC silicone wires for cover installation.
Guides signal line connection and battery installation steps.
Advises confirming battery lock status before takeoff.
Provides maximum dimensions for motor/battery and ESC cutting guide.
General