Plastic Tube
塑料管
Receiver Antenna Mount
接收机天线座
Cable Tie
扎带
Receiver Antenna
接收机天线
1
2
3
4
Receiver Antenna
接收机天线
Receiver antenna mount installation :
First insert the antenna into the antenna mount (see Figure 1); then pass the antenna through the plastic
tube and insert the plastic tube into the antenna mount (Figure 2); then take the cable tie from the set position.
(Figure 3);and finally fix the antenna mount with the cable tie at the tail tube position (Figure 4).
接收机天线座的安装:
首先将接收机天线插入接收机天线座内（如图1）；然后把接收机天线穿过塑料管，并将塑料管插入接收机天线
座内（如图2）；再把扎带从制定位置穿入（如图3）；最后将接收机天线座用扎带固定在尾部管位置（如图4）。
600 ASSEMBLY SECTION
Electric Device Install Diagram
Flybarless System
无平 衡翼系统
Page 25
To Next Page
Loading...
