IMPORTANT SAFETY INSTRUCTIONS
17 TASCAM CD-VT2
Names and functions of parts
Control panel
1 Display
Shows CD status during playback, device settings and
other information.
2 TEMPO key
Press this key to open the TEMPO CHANGE screen. You
can change the playback tempo and turn the VSA function
ON and OFF on this screen. (See “Changing the tempo”
and “Changing the pitch with the tempo” on page 26.)
3 KEY key
Press this key to open the KEY & PITCH screen.
You can change the playback pitch on this screen. (See
“Changing only the pitch” on page 26.)
4 VOCAL CANCEL key
Press this key to open the VOCAL CANCEL screen where
you can change the VOCAL CANCEL function settings.
(See “Reducing the sound of recorded vocals and solo
instruments” on page 27.)
5 EFFECT key
Press this key to open the EFFECTOR screen. Make mic
effect settings on this screen. (See “Using built-in effects”
on page 31.)
6 TIME DISPLAY key
Press this to open the TIME DISPLAY screen, which
shows the status of the CD during playback and other
information. (See “TIME DISPLAY screen” on page 21.)
7 LOOP key
Turns the loop playback and repeat playback functions ON
and OFF. When IN and OUT points are set, this key turns
To Next Page
Loading...
