IMPORTANT SAFETY INSTRUCTIONS
31 TASCAM CD-VT2
Using mics with the trainer
3 Use the VALUE (+, –) keys to adjust the level. The level
knob icon rotates as you change the value.
The input meter at the bottom of this screen shows the
total level of the signal input at the MIC IN jacks.
Using built-in effects
This device has a built-in mic effects processor. Press the
EFFECT key to open the EFFECTOR screen.
As shown in the gure above, in addition to BANK and
PRESET, the EFFECTOR screen also shows the LVL (level)
knob, an icon for the selected mic effect and the VCH (voice
change) icon. These all have adjustable settings.
Use the CURSOR (˙, ¥) keys to move between the LVL knob,
effect parameter knob and voice change icon. When you select
the LVL knob or other parameter, a pop-up appears for the
setting items. Use the CURSOR (§, ¶) keys to select settings
in the pop-up, and use the VALUE (+, –) keys to adjust these
settings.
BANK
Select bank 01–05 or BYPASS.
Using the PRESET item explained below, you can set a
preset effect for each bank. By making presets of settings that
you use frequently in each bank, you can quickly recall the
settings you desire just by switching through the banks.
Select BYPASS if you do not want to use effects.
To Next Page
Loading...
